:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 715
:POWer:CLResponse:DATA
(see page 1610)
Query Syntax
:POWer:CLResponse:DATA? [SWEep | SINGle]
The :POWer:CLResponse:DATA? query returns data from the Control Loop
Response (Bode) power analysis.
The comma-separated value format is suitable for spreadsheet analysis.
You can use the :POWer:CLResponse:TRACe command to specify whether to
include gain, phase, both gain and phase, or neither in the frequency response
analysis results.
The SWEep or SINGle option specifies whether to get the data from a sweep or
single-frequency analysis (see :POWer:CLResponse:FREQuency:MODE). If this
option is not specified, the data from the sweep analysis is returned by default.
Return Format
<binary_block><NL>
<binary_block> ::= comma-separated data with newlines at the end of each
row
See Also • ":POWer:CLResponse" on page 713
• ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA:GMARgin" on page 716
• ":POWer:CLResponse:DATA:GMARgin:FREQuency" on page 717
• ":POWer:CLResponse:DATA:PMARgin" on page 718
• ":POWer:CLResponse:DATA:PMARgin:FREQuency" on page 719
• ":POWer:CLResponse:FREQuency:MODE" on page 720
• ":POWer:CLResponse:FREQuency:SINGle" on page 721
• ":POWer:CLResponse:FREQuency:STARt" on page 722
• ":POWer:CLResponse:FREQuency:STOP" on page 723
• ":POWer:CLResponse:PPDecade" on page 724
• ":POWer:CLResponse:SOURce:INPut" on page 725
• ":POWer:CLResponse:SOURce:OUTPut" on page 726
• ":POWer:CLResponse:TRACe" on page 727
• ":POWer:CLResponse:WGEN:LOAD" on page 728
• ":POWer:CLResponse:WGEN:VOLTage" on page 729
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 730
To Next Page
Loading...
Need help?
General
