762 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:PSRR:DATA
(see page 1610)
Query Syntax
:POWer:PSRR:DATA? [SWEep | SINGle]
The :POWer:PSRR:DATA? query returns data from the Power Supply Rejection
Ratio (PSRR) power analysis.
The comma-separated value format is suitable for spreadsheet analysis.
You can use the :POWer:PSRR:TRACe command to specify whether to include gain
data in the PSRR analysis results.
The SWEep or SINGle option specifies whether to get the data from a sweep or
single-frequency analysis (see :POWer:PSRR:FREQuency:MODE). If this option is
not specified, the data from the sweep analysis is returned by default.
Return Format
<binary_block><NL>
<binary_block> ::= comma-separated data with newlines at the end of each
row
See Also • ":POWer:PSRR" on page 760
• ":POWer:PSRR:APPLy" on page 761
• ":POWer:PSRR:FREQuency:MAXimum" on page 763
• ":POWer:PSRR:FREQuency:MINimum" on page 764
• ":POWer:PSRR:FREQuency:MODE" on page 765
• ":POWer:PSRR:FREQuency:SINGle" on page 766
• ":POWer:PSRR:PPDecade" on page 767
• ":POWer:PSRR:SOURce:INPut" on page 768
• ":POWer:PSRR:SOURce:OUTPut" on page 769
• ":POWer:PSRR:TRACe" on page 770
• ":POWer:PSRR:WGEN:LOAD" on page 771
• ":POWer:PSRR:WGEN:VOLTage" on page 772
• ":POWer:PSRR:WGEN:VOLTage:PROFile" on page 773
To Next Page
Loading...
