Keysight Technologies InfiniiVision 4000 X Series

928 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:FLEXray:CHANnel
(see page 1610)
Command Syntax
:SBUS<n>:FLEXray:CHANnel <channel>
<channel> ::= {A | B}
The :SBUS<n>:FLEXray:CHANnel command specifies the bus channel, A or B, of
the FlexRay signal.
Query Syntax
:SBUS<n>:FLEXray:CHANnel?
The :SBUS<n>:FLEXray:CHANnel? query returns the current bus channel setting.
Return Format
<channel><NL>
<channel> ::= {A | B}
See Also • "Introduction to :TRIGger Commands" on page 1295
• ":SBUS<n>:FLEXray Commands" on page 924