:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1469
:WGEN<w>:OUTPut:SINGle
(see page 1610)
Command Syntax
:WGEN<w>:OUTPut:SINGle
When the single-shot output mode is selected (by the :WGEN<w>:OUTPut:MODE
command), the :WGEN<w>:OUTPut:SINGle command causes a single cycle of the
defined waveform to be output.
Sending this command multiple times will interrupt a slow signal output before
the cycle is completed.
See Also • ":WGEN<w>:OUTPut:MODE" on page 1467
To Next Page
Loading...
