1382 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
35 :TRIGger Commands
:TRIGger:TV:UDTV:ENUMber
(see page 1610)
Command Syntax
:TRIGger:TV:UDTV:ENUMber <count>
<count> ::= edge number in NR1 format
The :TRIGger:TV:UDTV:ENUMber command specifies the Generic video trigger's
Nth edge to trigger on after synchronizing with the vertical sync.
Query Syntax
:TRIGger:TV:UDTV:ENUMber?
The :TRIGger:TV:UDTV:ENUMber query returns the edge count setting.
Return Format
<count><NL>
<count> ::= edge number in NR1 format
See Also • ":TRIGger:TV:STANdard" on page 1381
• ":TRIGger:TV:UDTV:PGTHan" on page 1385
• ":TRIGger:TV:UDTV:HSYNc" on page 1383
To Next Page
Loading...
