Keysight Technologies InfiniiVision 4000 X Series User Manual

:MTESt Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 671
:MTESt:AMASk:CREate
(see page 1610)
Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask around the
current selected channel, using the tolerance parameters defined by the
:MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and :MTESt:AMASk:UNITs
commands. The mask only encompasses the portion of the waveform visible on
the display, so you must ensure that the waveform is acquired and displayed
consistently to obtain repeatable results.
The :MTESt:SOURce command selects the channel and should be set before using
this command.
See Also • "Introduction to :MTESt Commands" on page 667
• ":MTESt:AMASk:XDELta" on page 674
• ":MTESt:AMASk:YDELta" on page 675
• ":MTESt:AMASk:UNITs" on page 673
• ":MTESt:AMASk:SOURce" on page 672
• ":MTESt:SOURce" on page 697
Example Code • "Example Code" on page 667

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English