Keysight Technologies InfiniiVision 4000 X Series User Manual

:TRIGger Commands 35
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1313
:TRIGger:DELay:ARM:SOURce
(see page 1610)
Command Syntax
:TRIGger:DELay:ARM:SOURce <source>
<source> ::= {CHANnel<n> | DIGital<d>}
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :TRIGger:DELay:ARM:SOURce command selects the input used for the arming
edge in the Edge Then Edge trigger.
Query Syntax
:TRIGger:DELay:ARM:SOURce?
The :TRIGger:DELay:ARM:SOURce? query returns the current arming edge source.
Return Format
<source><NL>
<source> ::= {CHAN<n> | DIG<d>}
See Also • "Introduction to :TRIGger Commands" on page 1295
• ":TRIGger:DELay:ARM:SLOPe" on page 1312
• ":TRIGger:DELay:TDELay:TIME" on page 1314
• ":TRIGger:MODE" on page 1308

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English