EasyManua.ls Logo

Keysight Technologies InfiniiVision 4000 X Series

Keysight Technologies InfiniiVision 4000 X Series
1762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
:RECall Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 815
:RECall:LDF[:STARt]
(see page 1610)
Command Syntax
:RECall:LDF[:STARt] [<file_name>] [, <serialbus>]
<file_name> ::= quoted ASCII string
<serialbus> ::= {SBUS<n>}
<n> ::= 1 to (# of serial bus) in NR1 format
The :RECall:LDF[:STARt] command loads a LIN description file (LDF) symbolic data
file into the oscilloscope.
The <serialbus> parameter specifies which serial decode waveform the LIN
symbolic data will be loaded for.
See Also "Introduction to :RECall Commands" on page 810
":RECall:FILename" on page 814
":SBUS<n>:LIN:TRIGger" on page 982
":SBUS<n>:LIN:TRIGger:SYMBolic:FRAMe" on page 989
":SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal" on page 990
":SBUS<n>:LIN:TRIGger:SYMBolic:VALue" on page 991
":SEARch:SERial:LIN:MODE" on page 1217
":SEARch:SERial:LIN:SYMBolic:FRAMe" on page 1221
":SEARch:SERial:LIN:SYMBolic:SIGNal" on page 1222
":SEARch:SERial:LIN:SYMBolic:VALue" on page 1223
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".ldf".

Table of Contents

Related product manuals