702 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
27 :POD Commands
:POD<n>:SIZE
(see page 1610)
Command Syntax
:POD<n>:SIZE <value>
<n> ::= An integer, 1 or 2, is attached as a suffix to the command and
defines the group of channels that are affected by the command.
POD1 ::= D0-D7
POD2 ::= D8-D15
<value> ::= {SMALl | MEDium | LARGe}
The :POD<n>:SIZE command specifies the size of digital channels on the display.
Sizes are set for all pods. Therefore, if you set the size on pod 1 (for example), the
same size is set on pod 2 as well.
Query Syntax
:POD<n>:SIZE?
The :POD<n>:SIZE? query returns the digital channels size setting.
Return Format
<size_value><NL>
<size_value> ::= {SMAL | MED | LARG}
See Also • "Introduction to :POD<n> Commands" on page 699
• ":DIGital<d>:SIZE" on page 398
• ":DIGital<d>:POSition" on page 397
This command is only valid for the MSO models.
To Next Page
Loading...
