To Next Page

To Previous Page

:BUS<n> Commands 9

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 327

:BUS<n>:DISPlay

(see page 1610)

Command Syntax

:BUS<n>:DISplay <value>

<value> ::= {{1 | ON} | {0 | OFF}}

<n> ::= An integer, 1 or 2, is attached as a suffix to BUS

and defines the bus that is affected by the command.

The :BUS<n>:DISPlay command enables or disables the view of the selected bus.

Query Syntax

:BUS<n>:DISPlay?

The :BUS<n>:DISPlay? query returns the display value of the selected bus.

Return Format

<value> ::= {0 | 1}

See Also • "Introduction to :BUS<n> Commands" on page 322

• ":BUS<n>:BIT<m>" on page 323

• ":BUS<n>:BITS" on page 324

• ":BUS<n>:CLEar" on page 326

• ":BUS<n>:LABel" on page 328

• ":BUS<n>:MASK" on page 329

NOTE

This command is only valid for the MSO models.

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: