1034 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:NRZ:TRIGger:PATTern:VALue:WIDTh
(see page 1610)
Command Syntax
:SBUS<n>:NRZ:TRIGger:PATTern:VALue:WIDTh <width>
<width> ::= integer from 4 to 128 in NR1 format
When the VALue trigger mode is selected (:SBUS<n>:NRZ:TRIGger), the
:SBUS<n>:NRZ:TRIGger:PATTern:VALue:WIDTh command specifies the bit width
(length) of the value to trigger on.
The actual value to trigger on is set with the
:SBUS<n>:NRZ:TRIGger:PATTern:VALue:DATA command.
Query Syntax
:SBUS<n>:NRZ:TRIGger:PATTern:VALue:WIDTh?
The :SBUS<n>:NRZ:TRIGger:PATTern:VALue:WIDTh? query returns the specified
trigger value bit width (length).
Return Format
<width><NL>
See Also • ":SBUS<n>:NRZ:BITorder" on page 1022
• ":SBUS<n>:NRZ:TRIGger" on page 1032
• ":SBUS<n>:NRZ:TRIGger:PATTern:VALue:DATA" on page 1033
To Next Page
Loading...
