To Next Page

To Previous Page

416 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide

16 :DISPlay Commands

:DISPlay:GRATicule:TYPE

(see page 1610)

Command Syntax

:DISPlay:GRATicule:TYPE <type>

<type> ::= {FULL | MVOLt | IRE}

The :DISPlay:GRATicule:TYPE command sets the graticule (grid) type.

When the TV trigger type is selected (see ":TRIGger:MODE" on page 1308), and

the vertical scaling of at least one displayed channel is 140 mV/div, the

:DISPlay:GRATicule:TYPE command lets you select from these grid types:

• FULL — the normal oscilloscope grid.

• MVOLt — shows vertical grids, labeled on the left, from -0.3 V to 0.8 V.

• IRE — (Institute of Radio Engineers) shows vertical grids in IRE units, labeled on

the left, from -40 to 100 IRE. The 0.35 V and 0.7 V levels from the MVOLt grid

are also shown and labeled at the right. When the IRE grid is selected, cursor

values on the display are also shown in IRE units. However, cursor values via

the remote interface are not in IRE units.

The MVOLt and IRE grid values are accurate when the vertical scaling is

140 mV/division and the vertical offset is 245 mV.

Query Syntax

:DISPlay:GRATicule:TYPE?

The :DISPlay:GRATicule:TYPE? query returns the graticule (grid) type setting.

Return Format

<type> ::= {FULL | MVOL | IRE}

See Also • ":TRIGger:MODE" on page 1308

• ":CHANnel<n>:SCALe" on page 364

• ":CHANnel<n>:OFFSet" on page 353

• ":DISPlay:GRATicule:ALABels" on page 414

• ":DISPlay:GRATicule:INTensity" on page 415

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: