748 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:INRush:EXIT
(see page 1610)
Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:INRush:APPLy" on page 747
• ":POWer:INRush:NEXT" on page 749
• ":POWer:ITYPe" on page 750
To Next Page
Loading...
