EasyManua.ls Logo

Keysight Technologies InfiniiVision 4000 X Series

Keysight Technologies InfiniiVision 4000 X Series
1762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
:SAVE Commands 30
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 835
:SAVE:MULTi[:STARt]
(see page 1610)
Command Syntax
:SAVE:MULTi[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:MULTi[:STARt] command saves multi-channel waveform data to a file.
This file can be opened by the N8900A Infiniium Offline oscilloscope analysis
software.
See Also "Introduction to :SAVE Commands" on page 824
":SAVE:FILename" on page 827
":SAVE:PWD" on page 837
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".h5".

Table of Contents

Related product manuals