To Next Page

To Previous Page

Obsolete and Discontinued Commands 39

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1525

:MEASure:TSTOp

(see page 1610)

Command Syntax

:MEASure:TSTOp <value> [suffix]

<value> ::= time at the stop marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTOp command moves the stop marker (X2 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTOp?

The :MEASure:TSTOp? query returns the time at the stop marker (X2 cursor).

Return Format

<value> ::= time at the stop marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 529

• "Introduction to :MEASure Commands" on page 568

• ":MARKer:X1Position" on page 533

• ":MARKer:X2Position" on page 536

• ":MARKer:XDELta" on page 538

• ":MEASure:TDELta" on page 1520

• ":MEASure:TSTArt" on page 1524

NOTE

The short form of this command, TSTO, does not follow the defined Long Form to Short Form

Truncation Rules (see page 1612). The normal short form "TST" would be the same for both

TSTArt and TSTOp, so sending TST for the TSTOp command produces an error.

NOTE

The :MEASure:TSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X2Position command (see page 536) instead.

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: