Keysight Technologies InfiniiVision 4000 X Series User Manual

:CHANnel<n> Commands 11
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 361
:CHANnel<n>:PROBe:ZOOM
(see page 1610)
Command Syntax
:CHANnel<n>:PROBe:ZOOM {{0 | OFF} | {1 | ON}}
<n> ::= 1 to (# analog channels) in NR1 format
When the N2820A high-sensitivity current probe is used with both the Primary and
Secondary cables, the :CHANnel<n>:PROBe:ZOOM command specifies whether
this cable will have the Zoom In waveform (ON) or the Zoom Out waveform (OFF).
The other cable will have the opposite waveform.
Query Syntax
:CHANnel<n>:PROBe:ZOOM?
The :CHANnel<n>:PROBe:ZOOM? query returns the zoom setting.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also • ":CHANnel<n>:PROBe:RSENse" on page 358
• ":MEASure:DUAL:CHARge" on page 583
• ":MEASure:DUAL:VAMPlitude" on page 584
• ":MEASure:DUAL:VAVerage" on page 585
• ":MEASure:DUAL:VBASe" on page 586
• ":MEASure:DUAL:VPP" on page 587
• ":MEASure:DUAL:VRMS" on page 588

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English