Keysight Technologies InfiniiVision 4000 X Series

446 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
19 :FRANalysis Commands
:FRANalysis:FREQuency:STOP
(see page 1610)
Command Syntax
:FRANalysis:FREQuency:STOP <value>[suffix]
<value> ::= {100 | 1000 | 10000 | 100000 | 1000000 | 10000000 | 20000000
}
[suffix] ::= {Hz | kHz| MHz}
The :FRANalysis:FREQuency:STOP command sets the frequency sweep stop value.
The frequency response analysis is displayed on a log scale Bode plot, so you can
select from decade values in addition to the maximum frequency of 20 MHz.
Query Syntax
:FRANalysis:FREQuency:STOP?
The :FRANalysis:FREQuency:STOP? query returns the frequency sweep stop
setting.
Return Format
<value><NL>
<value> ::= {100 | 1000 | 10000 | 100000 | 1000000 | 10000000 | 20000000
}
See Also • ":FRANalysis:DATA" on page 441
• ":FRANalysis:ENABle" on page 442
• ":FRANalysis:FREQuency:STARt" on page 445
• ":FRANalysis:PPDecade" on page 447
• ":FRANalysis:FREQuency:MODE" on page 443
• ":FRANalysis:RUN" on page 448
• ":FRANalysis:SOURce:INPut" on page 449
• ":FRANalysis:SOURce:OUTPut" on page 450
• ":FRANalysis:WGEN:LOAD" on page 452
• ":FRANalysis:WGEN:VOLTage" on page 453
• ":FRANalysis:WGEN:VOLTage:PROFile" on page 454