Keysight Technologies InfiniiVision 4000 X Series User Manual

:TRIGger Commands 35
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1319
:TRIGger:EBURst:COUNt
(see page 1610)
Command Syntax
:TRIGger:EBURst:COUNt <count>
<count> ::= integer in NR1 format
The :TRIGger:EBURst:COUNt command sets the Nth edge at burst counter
resource. The edge counter is used in the trigger stage to determine which edge in
a burst will generate a trigger.
Query Syntax
:TRIGger:EBURst:COUNt?
The :TRIGger:EBURst:COUNt? query returns the current Nth edge of burst edge
counter setting.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also • "Introduction to :TRIGger Commands" on page 1295
• ":TRIGger:EBURst:SLOPe" on page 1321
• ":TRIGger:EBURst:IDLE" on page 1320

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English