:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 747
:POWer:INRush:APPLy
(see page 1610)
Command Syntax
:POWer:INRush:APPLy
The :POWer:INRush:APPLy command applies the inrush current analysis.
The Inrush current analysis measures the peak inrush current of the power supply
when the power supply is first turned on.
See Also • ":POWer:ITYPe" on page 750
• ":POWer:INRush:EXIT" on page 748
• ":POWer:INRush:NEXT" on page 749
• ":MEASure:PCURrent" on page 657
To Next Page
Loading...
