Keysight Technologies InfiniiVision 4000 X Series User Manual

:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 721
:POWer:CLResponse:FREQuency:SINGle
(see page 1610)
Command Syntax
:POWer:CLResponse:FREQuency:SINGle <value>[suffix]
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000
| 2000000}
[suffix] ::= {Hz | kHz| MHz}
The :POWer:CLResponse:FREQuency:SINGle command sets the single frequency
value. The control loop response analysis is displayed on a log scale Bode plot, so
you can select from decade values in addition to the minimum frequency of 20 Hz.
Query Syntax
:POWer:CLResponse:FREQuency:SINGle?
The :POWer:CLResponse:FREQuency:SINGle? query returns the single frequency
setting.
Return Format
<value><NL>
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000
| 2000000}
See Also • ":POWer:CLResponse" on page 713
• ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA" on page 715
• ":POWer:CLResponse:FREQuency:MODE" on page 720
• ":POWer:CLResponse:PPDecade" on page 724
• ":POWer:CLResponse:SOURce:INPut" on page 725
• ":POWer:CLResponse:SOURce:OUTPut" on page 726
• ":POWer:CLResponse:WGEN:LOAD" on page 728
• ":POWer:CLResponse:WGEN:VOLTage" on page 729
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 730

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English