Keysight Technologies InfiniiVision 4000 X Series User Manual

:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 919
:SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt
(see page 1610)
Command Syntax
:SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt <start>
<start> ::= integer between 0 and 124, in NR1 format.
When triggering on long frames (with the LDATa trigger type) that can have up to
255 data bytes, the maximum number of data bytes you can include in the trigger
specification is still only 12 bytes. In this case, you can use the
:SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt command to specify the starting
byte location where the data value should be found.
The starting byte location must be within the first 123 bytes when PTYPE is present
or 124 bytes when PTYPE is not present.
The :SBUS<n>:CXPI:TRIGger:PATTern:DATA:LENGth command lets you specify the
length of the data value to trigger on.
The :SBUS<n>:CXPI:TRIGger:PATTern:DATA command lets you specify the data
value to trigger on.
Query Syntax
:SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt?
The :SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt? query returns the start byte
setting.
Return Format
<start><NL>
<start> ::= integer between 0 and 124, in NR1 format.
See Also • ":SBUS<n>:CXPI:TRIGger" on page 913
• ":SBUS<n>:CXPI:TRIGger:IDFilter" on page 915
• ":SBUS<n>:CXPI:TRIGger:PTYPe" on page 916
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA" on page 917
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA:LENGth" on page 918
• ":SBUS<n>:CXPI:TRIGger:PATTern:ID" on page 920
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:CT" on page 921
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:DLC" on page 922
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:NM" on page 923

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English