:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 755
:POWer:ONOFf:EXIT
(see page 1610)
Command Syntax
:POWer:ONOFf:EXIT
The :POWer:ONOFf:EXIT command exits (stops) the turn on time/turn off time
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:ONOFf:THResholds" on page 758
• ":POWer:ITYPe" on page 750
• ":POWer:ONOFf:APPLy" on page 754
• ":POWer:ONOFf:NEXT" on page 756
• ":POWer:ONOFf:TEST" on page 757
To Next Page
Loading...
