1312 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
35 :TRIGger Commands
:TRIGger:DELay:ARM:SLOPe
(see page 1610)
Command Syntax
:TRIGger:DELay:ARM:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:DELay:ARM:SLOPe command specifies rising (POSitive) or falling
(NEGative) for the arming edge in the Edge Then Edge trigger.
Query Syntax
:TRIGger:DELay:ARM:SLOPe?
The :TRIGger:DELay:ARM:SLOPe? query returns the current arming edge slope
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 1295
• ":TRIGger:DELay:ARM:SOURce" on page 1313
• ":TRIGger:DELay:TDELay:TIME" on page 1314
To Next Page
Loading...
