486 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
20 :FUNCtion<m> Commands
:FUNCtion<m>:INTegrate:IOFFset
(see page 1610)
Command Syntax
:FUNCtion<m>:INTegrate:IOFFset <input_offset>
<m> ::= 1 to (# math functions) in NR1 format
<input_offset> ::= DC offset correction in NR3 format.
The :FUNCtion<m>:INTegrate:IOFFset command lets you enter a DC offset
correction factor for the integrate math waveform input signal. This DC offset
correction lets you level a "ramp"ed waveform.
Query Syntax
:FUNCtion<m>:INTegrate:IOFFset?
The :FUNCtion<m>:INTegrate:IOFFset? query returns the current input offset
value.
Return Format
<input_offset><NL>
<input_offset> ::= DC offset correction in NR3 format.
See Also • "Introduction to :FUNCtion<m> Commands" on page 460
• ":FUNCtion<m>:OPERation" on page 490
To Next Page
Loading...
