Keysight Technologies InfiniiVision 4000 X Series

:TRIGger Commands 35
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1299
:TRIGger:FORCe
(see page 1610)
Command Syntax
:TRIGger:FORCe
The :TRIGger:FORCe command causes an acquisition to be captured even though
the trigger condition has not been met. This command is equivalent to the front
panel [Force Trigger] key.
See Also • "Introduction to :TRIGger Commands" on page 1295