Keysight Technologies InfiniiVision 4000 X Series

1072 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:SENT:TRIGger:TOLerance
(see page 1610)
Command Syntax
:SBUS<n>:SENT:TRIGger:TOLerance <percent>
<percent> ::= from 1-28, in NR1 format.
The :SBUS<n>:SENT:TRIGger:TOLerance command specifies the tolerance
variation that is considered a violation.
The trigger tolerance can be up to the :SBUS<n>:SENT:TOLerance setting minus
two percent. For example, after sending ":SBUS1:SENT:TOLerance 20", the
:SBUS1:SENT:TRIGger:TOLerance setting can be from 1 to 18.
Query Syntax
:SBUS<n>:SENT:TRIGger:TOLerance?
The :SBUS<n>:SENT:TRIGger:TOLerance? query returns tolerance variation
percent setting.
Return Format
<percent><NL>
<percent> ::= from 1-28, in NR1 format.
See Also • ":SBUS<n>:SENT:CLOCk" on page 1040
• ":SBUS<n>:SENT:CRC" on page 1041
• ":SBUS<n>:SENT:DISPlay" on page 1042
• ":SBUS<n>:SENT:FORMat" on page 1044
• ":SBUS<n>:SENT:IDLE" on page 1046
• ":SBUS<n>:SENT:LENGth" on page 1047
• ":SBUS<n>:SENT:PPULse" on page 1048
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 1050
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 1051
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 1053
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 1055
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 1057
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 1059
• ":SBUS<n>:SENT:SOURce" on page 1061
• ":SBUS<n>:SENT:TOLerance" on page 1063
• ":SBUS<n>:SENT:TRIGger" on page 1064
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 1066
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 1067
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 1069
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 1071