1116 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:USB:SOURce:DMINus
(see page 1610)
Command Syntax
:SBUS<n>:USB:SOURce:DMINus <source>
<source> ::= {CHANnel<n>} for DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:USB:SOURce:DMINus command specifies which signal is used as
the USB D- source for the selected bus.
The D- source is only used for Low and Full Speed USB.
Query Syntax
:SBUS<n>:USB:SOURce:DMINus?
The :SBUS<n>:USB:SOURce:DMINus? query returns the specified D- source.
Return Format
<source><NL>
<source> ::= {CHAN<n> | DIG<d>}
See Also • ":SBUS<n>:USB:SOURce:DPLus" on page 1117
• ":SBUS<n>:USB:SPEed" on page 1119
To Next Page
Loading...
