To Next Page

To Previous Page

:SBUS<n> Commands 31

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1041

:SBUS<n>:SENT:CRC

(see page 1610)

Command Syntax

:SBUS<n>:SENT:CRC <format>

<format> ::= {LEGacy | RECommended}

The :SBUS<n>:SENT:CRC command specifies the format of the CRC. Either

Legacy (2008) or Recommended (2010).

Enhanced Serial Message CRCs are always calculated using the 2010 format, but

for the Fast Channel Messages, and for Short Serial Message CRCs, this setting is

used.

Query Syntax

:SBUS<n>:SENT:CRC?

The :SBUS<n>:SENT:CRC? query returns the CRC format setting.

Return Format

<format> ::= {LEG | REC}

See Also • ":SBUS<n>:SENT:CLOCk" on page 1040

• ":SBUS<n>:SENT:DISPlay" on page 1042

• ":SBUS<n>:SENT:FORMat" on page 1044

• ":SBUS<n>:SENT:IDLE" on page 1046

• ":SBUS<n>:SENT:LENGth" on page 1047

• ":SBUS<n>:SENT:PPULse" on page 1048

• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 1050

• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 1051

• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 1053

• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 1055

• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 1057

• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 1059

• ":SBUS<n>:SENT:SOURce" on page 1061

• ":SBUS<n>:SENT:TOLerance" on page 1063

• ":SBUS<n>:SENT:TRIGger" on page 1064

• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 1066

• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 1067

• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 1069

• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 1071

• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 1072

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: