Keysight Technologies InfiniiVision 4000 X Series

:RECall Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 813
:RECall:DBC[:STARt]
(see page 1610)
Command Syntax
:RECall:DBC[:STARt] [<file_name>] [, <serialbus>]
<file_name> ::= quoted ASCII string
<serialbus> ::= {SBUS<n>}
<n> ::= 1 to (# of serial bus) in NR1 format
The :RECall:DBC[:STARt] command loads a CAN DBC (communication database)
symbolic data file into the oscilloscope.
The <serialbus> parameter specifies which serial decode waveform the CAN
symbolic data will be loaded for.
See Also • "Introduction to :RECall Commands" on page 810
• ":RECall:FILename" on page 814
• ":SBUS<n>:CAN:TRIGger" on page 894
• ":SBUS<n>:CAN:TRIGger:SYMBolic:MESSage" on page 904
• ":SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal" on page 905
• ":SBUS<n>:CAN:TRIGger:SYMBolic:VALue" on page 906
• ":SEARch:SERial:CAN:MODE" on page 1187
• ":SEARch:SERial:CAN:SYMBolic:MESSage" on page 1193
• ":SEARch:SERial:CAN:SYMBolic:SIGNal" on page 1194
• ":SEARch:SERial:CAN:SYMBolic:VALue" on page 1195
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".dbc".