Keysight Technologies InfiniiVision 4000 X Series

:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 793
:POWer:SIGNals:SOURce:CURRent<i>
(see page 1610)
Command Syntax
:POWer:SIGNals:SOURce:CURRent<i> <source>
<i> ::= 1, 2 in NR1 format
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:SIGNals:SOURce:CURRent<i> command specifies the first, and
perhaps second, current source channel to be used in the power analysis.
Query Syntax
:POWer:SIGNals:SOURce:CURRent<i>?
The :POWer:SIGNals:SOURce:CURRent<i> query returns the current source
channel setting.
Return Format
<source><NL>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
See Also • ":POWer:SIGNals:AUTosetup" on page 776
• ":POWer:SIGNals:CYCLes:HARMonics" on page 777
• ":POWer:SIGNals:CYCLes:QUALity" on page 778
• ":POWer:SIGNals:DURation:EFFiciency" on page 779
• ":POWer:SIGNals:DURation:MODulation" on page 780
• ":POWer:SIGNals:DURation:ONOFf:OFF" on page 781
• ":POWer:SIGNals:DURation:ONOFf:ON" on page 782
• ":POWer:SIGNals:DURation:RIPPle" on page 783
• ":POWer:SIGNals:DURation:TRANsient" on page 784
• ":POWer:SIGNals:IEXPected" on page 785
• ":POWer:SIGNals:OVERshoot" on page 786
• ":POWer:SIGNals:VMAXimum:INRush" on page 787
• ":POWer:SIGNals:VMAXimum:ONOFf:OFF" on page 788
• ":POWer:SIGNals:VMAXimum:ONOFf:ON" on page 789
• ":POWer:SIGNals:VSTeady:ONOFf:OFF" on page 790
• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 791
• ":POWer:SIGNals:VSTeady:TRANsient" on page 792
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 794