1450 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
37 :WGEN<w> Commands
:WGEN<w>:FUNCtion:PULSe:WIDTh
(see page 1610)
Command Syntax
:WGEN<w>:FUNCtion:PULSe:WIDTh <width>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<width> ::= pulse width in seconds in NR3 format
For Pulse waveforms, the :WGEN<w>:FUNCtion:PULSe:WIDTh command specifies
the width of the pulse.
The pulse width can be adjusted from 20 ns to the period minus 20 ns.
Query Syntax
:WGEN<w>:FUNCtion:PULSe:WIDTh?
The :WGEN<w>:FUNCtion:PULSe:WIDTh? query returns the currently set pulse
width.
Return Format
<width><NL>
<width> ::= pulse width in seconds in NR3 format
See Also • "Introduction to :WGEN<w> Commands" on page 1435
• ":WGEN<w>:FUNCtion" on page 1446
To Next Page
Loading...
