848 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
30 :SAVE Commands
:SAVE:WAVeform:LENGth:MAX
(see page 1610)
Command Syntax
:SAVE:WAVeform:LENGth:MAX <setting>
<setting> ::= {{OFF | 0} | {ON | 1}}
The :SAVE:WAVeform:LENGth:MAX command specifies whether maximum
number of waveform data points is saved.
When OFF, the :SAVE:WAVeform:LENGth command specifies the number of
waveform data points saved.
Query Syntax
:SAVE:WAVeform:LENGth:MAX?
The :SAVE:WAVeform:LENGth:MAX? query returns the current setting.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also • "Introduction to :SAVE Commands" on page 824
• ":SAVE:WAVeform[:STARt]" on page 845
• ":SAVE:WAVeform:LENGth" on page 847
To Next Page
Loading...
