1444 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
37 :WGEN<w> Commands
:WGEN<w>:ARBitrary:STORe
(see page 1610)
Command Syntax
:WGEN<w>:ARBitrary:STORe <source>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<source> ::= {CHANnel<n> | WMEMory<r> | FUNCtion<m> | MATH<m>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
<m> ::= 1 to (# math functions) in NR1 format
The :WGEN<w>:ARBitrary:STORe command stores the source's waveform into the
arbitrary waveform memory.
See Also • ":WGEN<w>:ARBitrary:DATA" on page 1437
• ":WGEN<w>:ARBitrary:DATA:DAC" on page 1442
• ":SAVE:ARBitrary[:STARt]" on page 825
• ":RECall:ARBitrary[:STARt]" on page 812
To Next Page
Loading...
