Keysight Technologies InfiniiVision 4000 X Series User Manual

1530 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
39 Obsolete and Discontinued Commands
:MEASure:VSTOp
(see page 1610)
Command Syntax
:MEASure:VSTOp <vstop_argument>
<vstop_argument> ::= value for Y2 cursor
The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to the
specified value corresponding to the selected source. The source can be selected
by the MARKer:X2Y2source command.
Query Syntax
:MEASure:VSTOp?
The :MEASure:VSTOp? query returns the current value of the Y2 cursor.
Return Format
<value><NL>
<value> ::= value of the Y2 cursor in NR3 format
See Also • "Introduction to :MARKer Commands" on page 529
• "Introduction to :MEASure Commands" on page 568
• ":MARKer:Y1Position" on page 542
• ":MARKer:Y2Position" on page 544
• ":MARKer:YDELta" on page 545
• ":MARKer:X2Y2source" on page 537
• ":MEASure:SOURce" on page 615
• ":MEASure:TDELta" on page 1520
• ":MEASure:TSTArt" on page 1524
NOTE
The short form of this command, VSTO, does not follow the defined Long Form to Short Form
Truncation Rules (see page 1612). The normal short form, VST, would be the same for both
VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.
NOTE
The :MEASure:VSTOp command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:Y2Position command (see page 544) instead.

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English