Keysight Technologies InfiniiVision 4000 X Series User Manual

Obsolete and Discontinued Commands 39
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1533
:MTESt:AVERage
(see page 1610)
Command Syntax
:MTESt:AVERage <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :MTESt:AVERage command enables or disables averaging. When ON, the
oscilloscope acquires multiple data values for each time bucket, and averages
them. When OFF, averaging is disabled. To set the number of averages, use the
:MTESt:AVERage:COUNt command described next.
Query Syntax
:MTESt:AVERage?
The :MTESt:AVERage? query returns the current setting for averaging.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :MTESt Commands" on page 667
• ":MTESt:AVERage:COUNt" on page 1534
NOTE
The :MTESt:AVERage command is obsolete and is provided for backward compatibility to
previous oscilloscopes. Use the :ACQuire:TYPE AVERage command (see page 318) instead.

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English