Keysight Technologies InfiniiVision 4000 X Series User Manual

540 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
23 :MARKer Commands
:MARKer:XUNits:USE
(see page 1610)
Command Syntax
:MARKer:XUNits:USE
When DEGRees is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 degrees and the current X2 location as
360 degrees.
When PERCent is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 percent and the current X2 location as
100 percent.
Once the 0 and 360 degree or 0 and 100 percent locations are set, inputs to and
outputs from the :MARKer:X1Position, :MARKer:X2Position, and :MARKer:XDELta
commands/queries are relative to the set locations.
See Also • "Introduction to :MARKer Commands" on page 529
• ":MARKer:XUNits" on page 539
• ":MARKer:X1Y1source" on page 534
• ":MARKer:X2Y2source" on page 537
• ":MEASure:SOURce" on page 615
• ":MARKer:X1Position" on page 533
• ":MARKer:X2Position" on page 536
• ":MARKer:XDELta" on page 538

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English