To Next Page

To Previous Page

:MARKer Commands 23

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 533

:MARKer:X1Position

(see page 1610)

Command Syntax

:MARKer:X1Position <position> [suffix]

<position> ::= X1 cursor position in NR3 format

<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}

The :MARKer:X1Position command:

• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform (see

":MARKer:MODE" on page 531).

• Sets the X1 cursor position to the specified value.

X cursor units are set by the :MARKer:XUNits command.

Query Syntax

:MARKer:X1Position?

The :MARKer:X1Position? query returns the current X1 cursor position. This is

functionally equivalent to the obsolete :MEASure:TSTArt command/query.

Return Format

<position> ::= X1 cursor position in NR3 format

See Also • "Introduction to :MARKer Commands" on page 529

• ":MARKer:MODE" on page 531

• ":MARKer:X2Position" on page 536

• ":MARKer:X1Y1source" on page 534

• ":MARKer:X2Y2source" on page 537

• ":MARKer:XUNits" on page 539

• ":MEASure:TSTArt" on page 1524

NOTE

If the front-panel cursors are off, the marker position values are not defined and an error is

generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in the

front-panel Normal mode.

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: