:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1119
:SBUS<n>:USB:SPEed
(see page 1610)
Command Syntax
:SBUS<n>:USB:SPEed <speed>
<speed> ::= {LOW | FULL | HIGH}
The :SBUS<n>:USB:SPEed command specifies the speed of the USB interface for
the selected bus.
Query Syntax
:SBUS<n>:USB:SPEed?
The :SBUS<n>:USB:SPEed? query returns the speed setting.
Return Format
<speed><NL>
<speed> ::= {LOW | FULL | HIGH}
See Also • ":SBUS<n>:USB:SOURce:DPLus" on page 1117
• ":SBUS<n>:USB:SOURce:DMINus" on page 1116
• ":SBUS<n>:USB:SOURce:DIFFerential" on page 1118