:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 725
:POWer:CLResponse:SOURce:INPut
(see page 1610)
Command Syntax
:POWer:CLResponse:SOURce:INPut <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:CLResponse:SOURce:INPut command selects the oscilloscope
channel that is probing the power supply input.
Query Syntax
:POWer:CLResponse:SOURce:INPut?
The :POWer:CLResponse:SOURce:INPut? query returns the channel selection.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • ":POWer:CLResponse" on page 713
• ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA" on page 715
• ":POWer:CLResponse:FREQuency:MODE" on page 720
• ":POWer:CLResponse:FREQuency:STARt" on page 722
• ":POWer:CLResponse:FREQuency:STOP" on page 723
• ":POWer:CLResponse:PPDecade" on page 724
• ":POWer:CLResponse:SOURce:OUTPut" on page 726
• ":POWer:CLResponse:WGEN:LOAD" on page 728
• ":POWer:CLResponse:WGEN:VOLTage" on page 729
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 730
To Next Page
Loading...
