Keysight Technologies InfiniiVision 4000 X Series

:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 723
:POWer:CLResponse:FREQuency:STOP
(see page 1610)
Command Syntax
:POWer:CLResponse:FREQuency:STOP <value>[suffix]
<value> ::= {100 | 1000 | 10000 | 100000 | 1000000 | 10000000 | 20000000
}
[suffix] ::= {Hz | kHz| MHz}
The :POWer:CLResponse:FREQuency:STOP command sets the frequency sweep
stop value. The control loop response analysis is displayed on a log scale Bode
plot, so you can select from decade values in addition to the maximum frequency
of 20 MHz.
Query Syntax
:POWer:CLResponse:FREQuency:STOP?
The :POWer:CLResponse:FREQuency:STOP? query returns the frequency sweep
stop setting.
Return Format
<value><NL>
<value> ::= {100 | 1000 | 10000 | 100000 | 1000000 | 10000000 | 20000000
}
See Also • ":POWer:CLResponse" on page 713
• ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA" on page 715
• ":POWer:CLResponse:FREQuency:MODE" on page 720
• ":POWer:CLResponse:FREQuency:STARt" on page 722
• ":POWer:CLResponse:PPDecade" on page 724
• ":POWer:CLResponse:SOURce:INPut" on page 725
• ":POWer:CLResponse:SOURce:OUTPut" on page 726
• ":POWer:CLResponse:WGEN:LOAD" on page 728
• ":POWer:CLResponse:WGEN:VOLTage" on page 729
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 730