Keysight Technologies InfiniiVision 4000 X Series

1348 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
35 :TRIGger Commands
:TRIGger:NFC:TIMeout:ENABle
(see page 1610)
Command Syntax
:TRIGger:NFC:TIMeout:ENABle {1 | ON}
The :TRIGger:NFC:TIMeout:ENABle command enables the timeout period.
Currently, ON is the only valid setting.
With the ATRigger (Arm & Trigger) trigger event, if the second event does not
occur within the timeout period, the oscilloscope triggers when the timeout period
expires.
Query Syntax
:TRIGger:NFC:TIMeout:ENABle?
The :TRIGger:NFC:TIMeout:ENABle? query returns the timeout period enable
setting.
Return Format
<setting><NL>
{1}
See Also • ":TRIGger:NFC:AEVent" on page 1340
• ":TRIGger:NFC:ATTime" on page 1341
• ":TRIGger:NFC:RPOLarity" on page 1342
• ":TRIGger:NFC:SOURce" on page 1343
• ":TRIGger:NFC:STANdard" on page 1344
• ":TRIGger:NFC:TEVent" on page 1345
• ":TRIGger:NFC:TIMeout" on page 1347
• ":TRIGger:NFC:TIMeout:TIME" on page 1349