1414 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
36 :WAVeform Commands
:WAVeform:SEGMented:COUNt
(see page 1610)
Query Syntax
:WAVeform:SEGMented:COUNt?
The :WAVeform:SEGMented:COUNt query returns the number of memory
segments in the acquired data. You can use the :WAVeform:SEGMented:COUNt?
query while segments are being acquired (although :DIGitize blocks subsequent
queries until the full segmented acquisition is complete).
The segmented memory acquisition mode is enabled with the :ACQuire:MODE
command. The number of segments to acquire is set using the
:ACQuire:SEGMented:COUNt command, and data is acquired using the :DIGitize,
:SINGle, or :RUN commands.
Return Format
<count> ::= an integer from 2 to 1000 in NR1 format (count set by
:ACQuire:SEGMented:COUNt).
See Also • ":ACQuire:MODE" on page 307
• ":ACQuire:SEGMented:COUNt" on page 312
• ":DIGitize" on page 268
• ":SINGle" on page 293
• ":RUN" on page 291
• "Introduction to :WAVeform Commands" on page 1396
Example Code • "Example Code" on page 313
To Next Page
Loading...
