Keysight Technologies InfiniiVision 4000 X Series User Manual

Root (:) Commands 7
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 291
:RUN
(see page 1610)
Command Syntax
:RUN
The :RUN command starts repetitive acquisitions. This is the same as pressing the
Run key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 258
• ":SINGle" on page 293
• ":STOP" on page 295
Example Code
' RUN_STOP - (not executed in this example)
' - RUN starts the data acquisition for the active waveform display.
' - STOP stops the data acquisition and turns off AUTOSTORE.
' myScope.WriteString ":RUN" ' Start data acquisition.
' myScope.WriteString ":STOP" ' Stop the data acquisition.
See complete example programs at: Chapter 44, “Programming Examples,”
starting on page 1619

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English