:MEASure Commands 24
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 621
:MEASure:STATistics:RESet
(see page 1610)
Command Syntax
:MEASure:STATistics:RESet
This command resets the measurement statistics, zeroing the counts.
Note that the measurement (statistics) configuration is not deleted.
See Also • "Introduction to :MEASure Commands" on page 568
• ":MEASure:STATistics" on page 617
• ":MEASure:STATistics:DISPlay" on page 618
• ":MEASure:RESults" on page 608
• ":MEASure:STATistics:INCRement" on page 619
Example Code • "Example Code" on page 608
To Next Page
Loading...
