Keysight Technologies InfiniiVision 4000 X Series

:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1059
:SBUS<n>:SENT:SIGNal<s>:STARt
(see page 1610)
Command Syntax
:SBUS<n>:SENT:SIGNal<s>:STARt <position>
<s> ::= 1-6, in NR1 format.
<position> ::= from 0-23, in NR1 format.
The :SBUS<n>:SENT:SIGNal<s>:STARt command specifies the starting bit of the
Fast Signal being defined.
Fast Signal definition examples:
Query Syntax
:SBUS<n>:SENT:SIGNal<s>:STARt?
The :SBUS<n>:SENT:SIGNal<s>:STARt? query returns the Fast Signal starting bit
setting.
Return Format
<position><NL>
<position> ::= from 0-23, in NR1 format.
See Also • ":SBUS<n>:SENT:CLOCk" on page 1040
• ":SBUS<n>:SENT:CRC" on page 1041
• ":SBUS<n>:SENT:DISPlay" on page 1042
• ":SBUS<n>:SENT:FORMat" on page 1044
• ":SBUS<n>:SENT:IDLE" on page 1046
• ":SBUS<n>:SENT:LENGth" on page 1047
• ":SBUS<n>:SENT:PPULse" on page 1048
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 1050
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 1051
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 1053