:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 751
:POWer:MODulation:APPLy
(see page 1610)
Command Syntax
:POWer:MODulation:APPLy
The :POWer:MODulation:APPLy command applies the selected modulation
analysis type (:POWer:MODulation:TYPE).
The Modulation analysis measures the control pulse signal to a switching device
(MOSFET) and observes the trending of the pulse width, duty cycle, period,
frequency, etc. of the control pulse signal.
See Also • ":POWer:MODulation:SOURce" on page 752
• ":POWer:MODulation:TYPE" on page 753
• ":MEASure:VAVerage" on page 629
• ":MEASure:VRMS" on page 635
• ":MEASure:VRATio" on page 634
• ":MEASure:PERiod" on page 603
• ":MEASure:FREQuency" on page 595
• ":MEASure:PWIDth" on page 607
• ":MEASure:NWIDth" on page 599
• ":MEASure:DUTYcycle" on page 589
• ":MEASure:RISetime" on page 611
• ":MEASure:FALLtime" on page 590
To Next Page
Loading...
