768 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:PSRR:SOURce:INPut
(see page 1610)
Command Syntax
:POWer:PSRR:SOURce:INPut <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:PSRR:SOURce:INPut command selects the oscilloscope channel that
is probing the power supply input.
Query Syntax
:POWer:PSRR:SOURce:INPut?
The :POWer:PSRR:SOURce:INPut? query returns the channel selection.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • ":POWer:PSRR" on page 760
• ":POWer:PSRR:APPLy" on page 761
• ":POWer:PSRR:DATA" on page 762
• ":POWer:PSRR:FREQuency:MAXimum" on page 763
• ":POWer:PSRR:FREQuency:MINimum" on page 764
• ":POWer:PSRR:FREQuency:MODE" on page 765
• ":POWer:PSRR:PPDecade" on page 767
• ":POWer:PSRR:SOURce:OUTPut" on page 769
• ":POWer:PSRR:WGEN:LOAD" on page 771
• ":POWer:PSRR:WGEN:VOLTage" on page 772
• ":POWer:PSRR:WGEN:VOLTage:PROFile" on page 773
To Next Page
Loading...
