882 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:CAN:COUNt:RESet
(see page 1610)
Command Syntax
:SBUS<n>:CAN:COUNt:RESet
Resets the frame counters.
Errors • "-241, Hardware missing" on page 1551
See Also • ":SBUS<n>:CAN:COUNt:ERRor" on page 880
• ":SBUS<n>:CAN:COUNt:OVERload" on page 881
• ":SBUS<n>:CAN:COUNt:TOTal" on page 884
• ":SBUS<n>:CAN:COUNt:UTILization" on page 885
• "Introduction to :SBUS<n> Commands" on page 853
• ":SBUS<n>:MODE" on page 857
• ":SBUS<n>:CAN Commands" on page 877
To Next Page
Loading...
