Keysight Technologies InfiniiVision 4000 X Series

:FRANalysis Commands 19
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 443
:FRANalysis:FREQuency:MODE
(see page 1610)
Command Syntax
:FRANalysis:FREQuency:MODE <setting>
<setting> ::= {SWEep | SINGle}
The :FRANalysis:FREQuency:MODE command lets you select between the normal
swept frequency response analysis or analysis at a single frequency, which can be
useful when debugging.
Query Syntax
:FRANalysis:FREQuency:MODE?
The :FRANalysis:FREQuency:MODE? query returns the frequency mode setting.
Return Format
<setting><NL>
<setting> ::= {SWEep | SINGle}
See Also • ":FRANalysis:RUN" on page 448
• ":FRANalysis:FREQuency:SINGle" on page 444
• ":FRANalysis:FREQuency:STARt" on page 445
• ":FRANalysis:FREQuency:STOP" on page 446
• ":FRANalysis:PPDecade" on page 447
• ":FRANalysis:WGEN:VOLTage:PROFile" on page 454