Keysight Technologies InfiniiVision 4000 X Series

1538 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
39 Obsolete and Discontinued Commands
:MTESt:{STARt | STOP}
(see page 1610)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition system.
See Also • "Introduction to :MTESt Commands" on page 667
NOTE
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for backward
compatibility to previous oscilloscopes. Use the :RUN command (see page 291) and :STOP
command (see page 295) instead.